12
English
!
7KHDSSOLDQFHPXVWEHLQVWDOOHGE\DTXDOL¿HGSHUVRQ
in compliance with the instructions provided.
!
Wear gloves when carrying out installation and
maintenance operations.
AIR VENT
(for ducting versions)
!
Prepare the hole and the air vent duct (150 mm dia-
meter).
!
Use a duct of the minimum indispensible length.
!
Use a duct with as few elbows as possible (maximum
elbow angle: 90°).
!
Avoid drastic changes in the duct cross-section.
!
Use a duct with an as smooth as possible inside.
!
7KHGXFWPXVWEHPDGHRIFHUWL¿HGPDWHULDO
!
Do not connect the hood to smoke exhaust ducts
IRUWKHSURGXFWVRIFRPEXVWLRQERLOHUV¿UHSODFHV
stoves, etc).
!
For the air vents comply with the provisions laid down
by the competent authorities.
In addition, the air must not be evacuated through a
KROHLQWKHZDOOXQOHVVVSHFL¿FDOO\LQWHQGHGIRUWKLV
purpose.
!
Fit air intakes in the room to prevent the hood from
creating a negative pressure in the room (which must
not exceed 0.04 mbar); if the hood is used at the
same time as non-electrical equipment (gas-, oil- and
FKDUFRDO¿UHGVWRYHVHWFWKHH[KDXVWJDVPD\EH
sucked in by the heat source.
FILTERING OR DUCTING VERSION ?
7KHKRRGPD\EHLQ¿OWHULQJRULQGXFWLQJYHUVLRQ'HFL
-
de from the outset which type is to be installed.
)RUEHWWHUHI¿FLHQF\ZHUHFRPPHQGLQVWDOOLQJWKHKRRG
in the ducting version (if possible).
Ducting version
7KHKRRGSXUL¿HVWKHDLUDQGHYDFXDWHVLWWRWKHRXWVLGH
through an exhaust duct (diameter 150 mm).
Filtering version
7KHKRRGSXUL¿HVWKHDLUDQGUHF\FOHVWKHFOHDQDLU
back into the room. For this version, the following are
UHTXLUHGDLUEDIÀHUHGXFHUFKDUFRDO¿OWHU
7KHXSSHUÀXHDLUHYDFXDWLRQVORWVPXVWEHSRVLWLRQHG
at the top.
CONTROLS
MOTOR SWITCH (A)
0 –
Motor off
1 –
Motor on at 1
st
speed
2 –
Motor on at 2
nd
speed
3 –
Motor on at 3
rd
speed
LIGHT SWITCH (B)
0 – Light off
1 – Light on
B
MAINTENANCE
!
Before cleaning or maintenance cut the power.
Cleaning the hood
WHEN TO CLEAN IT: clean it at least every 2 months
WRSUHYHQWWKHULVNRI¿UH
EXTERNAL CLEANING: use a cloth moistened in luke-
warm water and neutral detergent (for painted hoods);
XVHVSHFL¿FSURGXFWVIRUVWHHOFRSSHURUEUDVVKRRGV
INTERNAL CLEANING: use a cloth (or brush) soaked
in denatured ethyl alcohol.
WHAT NOT TO DO: do not use abrasive or corrosive
products (e.g. metal sponges, brushes, too hard bru-
shes, very aggressive detergents, etc.)
&OHDQLQJWKHJUHDVH¿OWHUV
WHEN TO CLEAN IT: clean it at least every 2 months
WRSUHYHQWWKHULVNRI¿UH
HOW TO REMOVE THE FILTERS: push the catch near
the handle towards the rear of the hood and pull the
¿OWHUGRZQZDUGV
HOW TO CLEAN THE FILTERS: hand wash or in the
dishwasher using a neutral detergent. If washing in the
GLVKZDVKHUSRVVLEOHGLVFRORUDWLRQRIWKH¿OWHUVGRHVQRW
in any way compromise their functioning.
EN
