Use a #3 phillips screwdriver to install screws into all
four corners. Install the remaining screws. Tighten
top, bottom and sides alternately until screw heads
are flush to create a watertight seal.
Do not overtighten. Do not use a power drill.
After the faceplate is secured, use a knife to trim the
liner inside the mouth of the High Flow Skimmer.
Position pond liner over the High Flow Skimmer
mouth and hold it in place. Smooth out liner so that it
is free of wrinkles and folds. Wipe clean.
Make a 3” wide incision through the centered liner
3/4” below the top of the High Flow Skimmer open-
Using FreezeFlex reduces the amount of plumbing
joints needed and lowers the potential for leaks.
FreezeFlex is more freeze tolerant than Kink Free and
glues to standard scheduled 40 PVC fittings.
Trench for FreezeFlex PVC Pipe
Dig a trench for the discharge pipe. Use
the side closest to your water return or waterfall.
