Savi SaviTag ST-614, Installation Manual

Page: 21 / 28

Mounting SaviTag ST-614/ST-615
SaviTag ST-614/ST-615 Installation Guide 21
a few hours. But 3M has successfully applied PST to exposed surfaces
at temperatures as low as 40 degrees Fahrenheit. Even at these lower
temperatures, tags can be installed immediately after PST application;
full adhesion strength will be achieved within 24 hours.
Make sure you have the following cleaning materials available:
◆
General purpose cleaner. Any commercial cleaner with a degreaser;
for example Formula 409® Cleaner, Ajax® All-Purpose Cleaner,
or Simple Green® All-Purpose Industrial Degreaser
◆
Rags or paper towels
◆
Scrub brush, bucket, and mild soap and water solution if needed
To clean the surface:
1.
Determine where the
SaviTag ST-614/ST-615 is
to be attached to the
shipping container or asset.
Be sure that the surface to
which the tapes will be
applied is flat.
2.
Spray a liberal amount
of general purpose cleaner
onto the mounting surface.