SHA-B6xx-00 | 009-1650-01 | 180530
Copyright 2018 Savant Systems, LLC
45 Perseverance Way, Hyannis, MA 02601
| 508.683.2500
2 of 2
5.
Connect the control and power wires exiting the rear of the mount to the wires exiting
the wall/ceiling. Savant recommends using Dolphin type crimp connectors or similar
when splicing the wires.
Note:
The wire colors shown in tables are the colors used in the Savant SHA-W1000-00
cable.
Power Wire
SHA-W1000-00
White
White/Black
Black
Red
Control Wire
SHA-W1000-00
Red
Green
Orange/White
Brown
Black
Orange
6.
Prepare the wall and install the hanger bolt. Leave
1/2
inch of the machine thread exposed.
HELPFUL!
Savant recommends using a hanger bolt installation tool (8-32 thread) when screwing the hanger bolt into the wall. DO NOT
use the provided sleeve to drive the hanger bolts into wall as damage to the sleeve will occur.
7.
Install the supplied #6 flat head screw
⁹/₁₆
inch directly above or below the hanger bolt (measurements are made from the center point
of the hanger bolt). With the shade mount installed, this screw sits inside the opening in the rear of the mount and keeps the mount from
twisting.
8.
With a
³/₃₂
inch hex key, turn the hex head set screw installed in the 1 inch mounting sleeve, so it doesn't protrude from either side of the
sleeve. When complete, the shade mount sleeve should be able to slide in and out of the hole in the rear of the shade mount. See
Hori-
zontal
and
Vertical
Mount diagrams above for position of the hole.
9.
Screw the mounting sleeve onto the hanger bolt until the hex head set screw in the
sleeve is positioned slightly offset from the hole in the shade mount (see diagram).
10. Slide the shade mount over the sleeve until the set screw is visible through hole on
side of mount (Insert wires from step 5 above into wall as required). With a
³/32
inch
hex key, turn the set screw counterclockwise to back off the set screw a bit until it
rests within the hole on the side of the mount. This pulls the mount tight against the
wall or ceiling.
Leave set screw
offset from hole
in shade mount
as shown
Mount Sleeve
11.
Verify the shade mount is tight to the wall or ceiling. If not, turn in the set screw, remove the shade mount, and adjust the mounting sleeve
to ensure the mount is pulled tight against the wall or ceiling.
