IRX-LN01 | 009-0908-02 | 160706
45 Perseverance Way, Hyannis, MA 02601
Copyright © 2016 Savant Systems, LLC
| 508.683.2500
Rear Panel
LINK
RJ-45 port used for extended link
connection to input HDMI audio and video
signals (Extended Link Out) from VOM-
LN02 or VOM-LN04.
Grounding terminal: optional use
LAN PoE
RJ-45 Cat5e/Cat6 port allows 10/100
Base-T (auto-negotiating) communication
between a LAN and the embedded CPU at
10/100 data rates.
Green
: (right) indicates an Ethernet speed
of 100 Mb.
Off
: indicates an Ethernet speed of 10 Mb.
Green
: (left) indicates Ethernet data
activity.
Power over Ethernet (PoE) is supported
on this port.
Wiring and Connectors
RS-232 Wiring
Important
: If you are using RJ-45 to DB-9 adapters not supplied by
Savant, be sure to terminate any wires required for
communication/control within the adapter. Ensure that all wires
required for communication/control are not terminated in the
connecter. Also, ensure that the unused wires in the connector are cut
to prevent them shorting out, as they are still terminated in the RJ-45
connector on the controller side.
IR Port Layout and Pinouts
Additional Documentation
Additional Documentation is available on the Savant Community.
•
4-Port Output Modules: VOM-LN04-01 Quick Reference Guides
•
RS-232 Conversion to DB-9 and RS-422/485 Pinout Application
Note
Required System Components
•
VOM-LN04-01 - Video output modules using HDBaseT
technology through Cat5e or Cat6 cabling.
•
SmartMediaPro - SSP-XXXX
•
Savant Host - HST-XXXX or SVR-XXXX
•
Ethernet Network - Enterprise-grade network deployment
enabled with PoE IEEE 802.3af standard
Installing the IRX-LN01
To install the IRX-LN01 into a standard 3-gang box, do the following:
1.
Take the LINK and LAN PoE cables from inside the 3-gang box
and connect them to their respective ports on the IRX-LN01 as
shown above.
IMPORTANT/Rear Connection Cables
: Savant recommends mounting the
IRX-LN01 into a low voltage 3-gang installation box (open back) to
allow room for the rear cable connections. A standard 3-gang junction
box can also be used. Please note the following:
•
Do not use shallow installation boxes.
•
Do not use cables with a long boot (For example, patch
cables or inadequate bend radius).
2.
Carefully slide the IRX-LN01 into the 3-gang box. Ensure the
cables do not get damaged.
3.
Align the mounting holes on the IRX-LN01 and 3-gang box and
secure with the four screws.
4.
Make required connections to the front of the IRX-LN01.
HELPFUL INFORMATION!!
To avoid HDBaseT signal loss, Savant recommends making a direct
end-to-end (homerun) connection when running the Cat 5e/6/7
cabling. Patch panels, wall plates, or similar types of splicing products
allow noise to be introduced which reduces the quality of the video
and in some instances video loss.
