23
•
ASSEMBLING THE HOOD
Warning
The hood must be installed in
compliance with all applicable regulations
concerning the ventilation of premises. In
France these regulations are described in
DTU 61.1 from the CSTB. In particular, the
evacuated air should never be conveyed to
a duct used to evacuate smoke from
appliances that use gas or other
combustible fuels. Unused ducts may only
be used after approval from a competent
specialist.
The distance between the supporting surface for
the cooking vessels on the hob and the lower part
of the hood must be at least 650 mm. If the
instructions for installation for the hob specify a
greater distance, this has to be taken into account.
- Fixing to the wall:
Draw a line on the wall in vertical line with your hob.
Mark the first 2 holes to be drilled in the wall,
respecting the distances indicated in fig. 3. Drill the
2 holes and fit the screw anchors provided.
Bear in mind that the distance between the lower
edge of the hood and the hob must be min. 650 mm.
- Fix the metal bracket (A) to the wall using the 2
holes just drilled (fig. 4); the screws for fixing the
bracket are provided. Use the 2 cut-out triangles
on the bracket to position it exactly along the
vertical axis of the hood.
- Hang the hood on the bracket (fig. 5). Adjust the
horizontal position moving the hood to the right or
left so that it is aligned with the wall units.
- When adjustment has been completed, without
removing the hood, mark the other 4 holes to be
drilled (C) in the wall. Remove the hood and drill the
holes marked (8 mm diameter). Then use the 4
screw anchors and the 4 screws provided for final
fixing.
- Install the flange in the device air outlet and press
slightly (fig.6). In the case of installation with air
evacuation to the outside, fitting the non-return
valve prevents the wind from entering and the air
from returning. Caution: Before fastening the air
exhaust pipe to the motor, check that the non-
return valve on the air vent can move freely.
2 / INSTALLING YOUR APPLIANCE
EN
fig. 3
fig. 4
fig. 5
fig. 6
Summary of Contents for SHD 821 BF1
Page 32: ...04307956...
