å
Carefully stand your unit upright.
å
Fasten the CENTER FRONT BRACE (T) to the CENTER FRONT
MOLDING (DD). Use two SILVER 1-5/8" MACHINE SCREWS (EEE)
through the CENTER FRONT BRACE (T), CENTER FRONT
MOLDING (DD), and into the KNOBS (AAA).
å
Fasten two EXTENSION RAILS (LL) to the UPPER ENDS (G and H).
Use four GOLD 5/16" FLAT HEAD SCREWS (NNN).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
shown in the enlarged diagram. Then, slide the inner cartridge of the
EXTENSION RAIL out to fi nd the other hole that lines up with the hole
in the END. Turn a SCREW into this hole.
Step 20
412079
www.sauder.com/services
Page 25
LL
LL
G
H
AAA
T
DD
Open end
Open end
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
3S
SILVER 1-5/8" MACHINE SCREW
(2 used for the KNOBS)
EEE
