Step 7
427719
www.sauder.com/service
Page 12
å
Separate the EXTENSION SLIDES (45MC) from the EXTENSION RAILS (45MA) as
shown in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (45MA) to the ENDS (A and B). Use eight GOLD
5/16" FLAT HEAD SCREWS (3S) through holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the
enlarged diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to find
the other hole that lines up with the hole in the END. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Push the black lever in and pull the SLIDE from the RAIL.
45MA
45MC
GOLD 5/16" FLAT HEAD SCREW
(8 used for the RAILS)
3S
3
2
1
1
2
3
4
4
Open end
Open end
4
7
A
B
After fastening the EXTENSION RAILS to the
RIGHT END (A), the SAFETY STOPS should touch
the top edge of the RAILS. If the gap is larger than
1/16", the drawers could lock up and not open. If
this happens, open two drawers at the same time to
override the interlock system. Remove the drawers
to re-adjust the INTERLOCK TRACK assembly.
3
2
1
1
2
3
4
4
