å
Separate the EXTENSION SLIDES (45MC) from the EXTENSION RAILS (45MA) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (45MA) to the ENDS (A and B). Use four GOLD 5/16" FLAT HEAD SCREWS (3S) through
holes #1 and #4.
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into
this hole.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Step 6
A
B
Open end
Open end
Push the black lever in and pull the SLIDE from the RAIL.
45MA
45MC
GOLD 5/16" FLAT HEAD SCREW
(4 used for the RAILS)
3S
3
2
1
4
7
1
2
3
4
427307
www.sauder.com/service
Page 11
