Step 2
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the enlarged diagram
below. Be prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the RIGHT END (A) and UPRIGHT (C). Use twelve BLACK 1/2" PAN
HEAD SCREWS (18).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide
the inner cartridge of the EXTENSION RAIL in to fi nd the other holes that line up with the holes in the END
and UPRIGHT. Turn a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
Page 6
www.sauder.com
420645
A
C
Push the black lever up and
pull the SLIDE from the RAIL.
1
1
2
Use these holes.
Open end
BLACK 1/2" PAN HEAD SCREW
(12 used in this step)
18
1
1
1
Open end
Open end
This HIDDEN CAM
must be here.
These holes are
closer to this edge.
