Step 7
418735
www.sauder.com/service
Page 11
å
Carefully turn your unit over onto its front edges. Unfold the
BACK (I) and lay it over your unit.
å
Make equal margins along all four edges of the BACK (I). Push
on opposite corners of your unit if needed to make
it "square".
å
Fasten the BACK (I) to your unit using the NAILS (1N).
å
NOTE: Do not tap NAILS into the holes that line up over the
SHELF (H) at this time.
å
Fasten the SMALL BACK (J) to your unit using the NAILS (1N).
å
NOTE: The SMALL BACK (J) overlaps the BACK (I). Be sure to
tap nails in the holes that line up over the SHELF (H).
å
Using your hammer, gently tap four TACK GLIDES (12E)
into the bottom edges of the ENDS (C and E) and
BASE MOLDING (M34).
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
Unfi
nished
sur
face
These holes must line
up over the SHELF (H).
NAIL
(57 used in this step)
1N
I
Unfi
nished
sur
face
J
I
J
12E
C
E
For support, place packing
foam and magazines here.
M34
H