8
8
S
te
p
Page 12
www.sauder.com/services
414817
Carefully turn your unit over onto its front edges and lay the LARGE BACK (L) over your unit.
Make equal margins along all four edges of the LARGE BACK (L). Push on opposite corners of your unit if needed to make it
“square”.
Fasten the LARGE BACK (L) to your unit using the NAILS (1N).
NOTE: You will not fasten NAILS into the bottom row of holes in the LARGE BACK (L) until you fasten the SMALL BACK (K).
Next, fasten the SMALL BACK (K) to your unit using the NAILS. The SMALL BACK (K) will overlap the LARGE BACK (L).
When fastening the SMALL BACK, line up the top set of holes in the SMALL BACK with the bottom set of holes in the LARGE
BACK first.
With your hammer, gently tap four TACK GLIDES (12E) into the bottom edges of the LOWER ENDS (C and D) and LEGS (O).
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
NAIL
(43 used in this step)
1N
C
D
O
O
K
L
Un
fi nished
surface
Un
fi nished
surface
12E
Do not tap NAILS into the bottom
row of the LARGE BACK (L) until
you fasten the SMALL BACK (K).
When fastening SMALL BACK (K),
start with the top row of holes fi rst. Line
up the holes in the SMALL BACK (K)
with the holes in the LARGE BACK (L).
