å
With someone’s help, carefully turn your unit over onto its front
edges. Unfold the BACK (P2) and lay it over the center of your unit.
å
Make equal margins along all four edges of the BACKS (P2). Push
on opposite corners of your unit if needed to make it “square”.
å
Fasten the BACK (P2) to your unit using fi fty-three NAILS (BBB).
å
Lay the BACKS (O2) over the outside of your unit.
å
Make equal margins along three edges of the BACKS (O2). Push
on opposite corners of your unit if needed to make it “square”.
The BACKS (O2) will overlap the center BACK (P2).
å
Fasten the BACKS (O2) to your unit using the remaining NAILS (BBB).
å
NOTE: Be sure to tap NAILS into the holes that line up over the
UPRIGHTS (E, F, G, and H), TOPS (J and K), and SHELF (L).
å
NOTE: Perforations have been provided for access through the
LARGE BACK. Carefully cut out the holes needed.
å
Tap eight TACK GLIDES (QQ) into the ENDS (A and B) and
UPRIGHTS (F and G).
Step 19
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Caution
These holes must line up over the
UPRIGHTS, TOPS and SHELF.
NAIL
(126 used in this step)
BBB
A
B
F
G
For support, place packing
foam and magazines here.
The BACKS (O2) will overlap
the CENTER BACK (P2).
The BACKS (O2) will overlap
the CENTER BACK (P2).
O2
O2
P2
403932
www.sauder.com/services
Page 23
