Saturn ST-CC7113, Manual, Page: 5 / 64

4
Filling with Water
Make sure iron is unplugged and the
thermostat dial is in the MIN position.
Place iron on the heel rest, tilt forward
approximately 45 angle and pour water
into the water-filling opening to the MAX
position of the water tank.
Dry Ironing
1. Set the steam selector to position O
(=No Steam)
2. As per washing label of various
clothes, set the correct ironing temper-
ature to begin ironing.
Steam Ironing
1. Fill water in the iron as per the wa-
ter-filling methods.
2. Plug the appliance in the socket.
3. If only set thermostat knob to MAX
position as per the temperature indicator,
steam iron will be available, otherwise
water may leak from the soleplate.
4. It indicates that the temperature has
been ready until the indicator light goes
off.
5. Set the steam selector correctly, in-
crease steam output by pushing the
steam selector back and decrease steam
output by forward.
Caution: Synthetic fabric, nylon, syn-
thetic silk and silk cannot use the steam
iron, otherwise it will damage the finish
of surface.
Burst of Steam
This function works well for tough wrin-
kles and heavy fabrics. By pressing
“Burst of Steam” button, an intense
burst of steam is emitted from the sole-
plate, this can be very useful when re-
moving stubborn creases. The shot of
steam facility can be used only while
ironing with high ironing temperature.
For optimal result, there should be 5
seconds rest between presses of the
steam button. To prevent leaking water
from the soleplate does not press the
steam button continuously for more
than 5 seconds. Also allow at least one
minute interval before applying this
burst of steam function.
Spraying Methods
At any temperature by pressing the
spray button a couple of times, the
laundry can be damped down. Ensure
that there is enough water in the water
tank.
Type of Fabric and Thermostat knob
Dial
Caution
Please note that on
the label means that this
article should not ironed.
Instructions
on Label Type of
Fabric Thermostat
Dial
Nylon
Silk
MIN
MAX
Wool
Cotton
Linen
Cleaning and Maintenance:
Before cleaning, remove the plug from
the socket and allow the iron to cool
down sufficiently.
1. Wipe off the soleplate with a damp
cloth and a non-abrasive (liquid) clean-
er.
2. If the fiber is adhered to the soleplate,
use a damp cloth with vinegar to wipe
off the soleplate.
3. Never use strong acid or alkali in or-
der to avoid damaging the soleplate.
4. If the scale blocks the steam hole,
please remove the scale with toothpick;
do not damage the surface of soleplate.
5. Stand the iron on its end and let it
cool down sufficiently, and meantime
pour any remaining water out of the box,
set the steam knob to position “O”.
Troubleshooting
Pro-
blem
Possible
Reasons Solving
Not
enough
heat or
Too
heat
Rotate
thermo-
stat dial
improp-
erly or
unplug-
ging
Correct Ther-
mostat dial in
position and
check if the iron
is plugged.
No
steam or
Leakage
The
thermo-
stat dial
has been
set to
MIN
Set the thermo-
stat dial to the
required posi-
tion.