3
E
E
LUCE VERDE SLIM
Assembly instruction
Date: 01.10. 2015
Light fixture with canopy –
Connection of the light fixture
with separate power supply cable
Mounting of the canopy
Make sure the ceiling has sufficient support capacity!
1. Fit the base of the canopy to the ceiling with the 4 mounting
points. Ø Drill 6mm / 1/4“ holes and anchor to fasten canopy
to ceiling (see scale sketch on the left).
2. Connect the power supply and the control signal to the terminal
block of the canopy (see wiring diagram page 8.
Connection of the light fixture
3. Fix light fixtures with 4 cables (depending on light fixture
diameter) to the canopy at the provided cable grippers and
align by applying light pressure on the steel cable grippers.
Observe minimum / maximum suspension height on page 4.
Consider the polarity of the current-carrying cables in
accordance with the markings on the light fixture and the
canopy.
Never adjust the suspension under pressure. The steel
cables might get damaged.
4. Lock the cable grippers in place by use of the insulated knurled screw.
5. Shorten excessive steel cables in order to prevent short circuits.
Shortened cables can only be replaced by the factory!
6. Insert the power supply line through the side of the ceiling plate
and connect it to the terminal block in accordance with the wiring
diagram (p. 8)
7. Mount the canopy cover and fasten it with screws from the side.
8. Check whether the light fixture is functioning.
Canopy with mounted cover
Canopy Ø 290 mm / 11,4“ with 4 steel cables