CAUTION
・
Set up this product on the same floor as the SG112-ex main unit so that the SG112-ex
and this product do not protrude from desks, etc.
・
When setting this product on the floor or a stand, make sure not to get your fingers or
hands pinched.
・
Do not carry this product with media loaded in it. The media could fall out and cause an injury.
・
Be careful in handling this product so that injuries are not sustained from this product's
corners.
1
．
Set and install the Media guide hook on the SG112-ex’s Media discharge outlet.
Depending upon the media’s size, the Media guide does not need to be installed.
2
．
Adjust the position while pushing on the Media stopper’s [PUSH] section.
Match the lengths up to the Media stopper from the ends of this product to the lengths of the media.
3
．
Place this product in front of the SG112-ex’s Media discharge outlet.
At this time, set this product and the SG112-ex so that there is no clearance in between them.
* In this product the media is stacked up to a height of 35
mm.
Remove the media before it exceeds 35 mm. Not doing so may cause a media jam.
Installing this Product
Lengths of the media
Media stopper
Media guide