SATO CL6NX, Kitting Manual, Page: 14 / 17

CL6NX KITTING MANUAL
<Check and adjust after assembly Dispenser-kit>
<Check contents and adjust>
Ⅰ
. Dispense-Sensor function
Confirm that the next-label is printed when peeling-off the label.
(next-label does not printed before peeling-off the label)
Ⅱ
. Dispense functions
(1) Confirm the label condition of after peeling-off
If it is a/b (NG) case, please adjust “Offset”
(a) Label is not retained on Dispense-
bar (b) It doesn’t take peeling the label easily
NG
Backing-paper
Label
OK
NG
2~4mm (Reference)
Power
Soft-R
//
Soft-L
Back
Enter
Navigation
<Adjust method of
“Offset”>
(1) Set “Offset” value
In case of (a); Offset value

Reduce ( )
(b);

Increase ( )
(2) After setting,
By press
｢
Soft-R
｣
key, printer is issued Test-printing.
When Label-pitch is less than 100mm,
Press
｢ ｣
x3 times, press the [Soft-R] key.
Confirm the label-stop position is OK or NG.
If it was NG, please perform (1)~(2) again.
Then
If printing-position needs to adjust,
please set it by “Pitch” value.
//
Test-print
Label stop
position adjust
Printing position
adjust
Page.12
DS KIT +
RW
MODEL
DS KIT MODEL