Page 6 of 7
Figure 7
3.2
There are 6 output pins for printer’s application; the timing chart is as Figure 8.
(1)
Pin 10
Serv_Req:
a.
The signal will active when printer is during normal printing process.
b.
The timing is same as printer’s printing period.
(2)
Pin 11
End Print:
a.
It indicates the printer’s status and active when print job was done.
b.
The action timing is fixed to 500ms.
(3)
Pin 12
Media out:
a.
It indicate the media status and active when media (paper) out happened.
b.
This signal will be cleared when “Re-Print” signal received, and if the status of media
out was still exist, it will back to the last situation and waiting to remove this issue.
(4)
Pin 13
Ribbon out:
a.
It indicate the ribbon status and active when ribbon out happened.
b.
This signal will be cleared when “Re-Print” signal received, and if the status of ribbon
out was still exist, it will back to the last situation and waiting to remove this issue.
(5)
Pin 14
Data Ready:
a.
It indicate the printer’s status and active when printer in idle state.
b.
In this state, printer could accept input signal to start print job.
Summary of Contents for ARGOX GPIO
Page 1: ...Service Manual GPIO ...
Page 9: ......
