AS-9400BT
User Guide
4
2
Get started
This chapter provides information about how
to install, connect and use your scanner to do
your work, and how to charge and replace
your battery.
2.1
Charging and Installation
This section describes how to charge and set
up your scanner.
2.1.1
Charging Your Scanner
AS-9400BT contains a lithium-ion battery that is
partially charged at the factory. You might want to
charge it to full before your use it. The battery life
varies depending on usage.
You can charge the battery by connecting the cradle
with a USB (type C) cable to your computer, or with
a power supply, which charges the battery faster.
When your scanner is fully charged, your cradle’s
LED turns to green.
Note: The percentage of power measured is for
reference only and the actual value may vary
depending on the battery power error.
Charging with
Full Charge Time
Power Supply
4 hours
USB Cable (USB2.0)
5 hours
USB Cable (USB3.0)
4 hours
Caution
Keep the charging pins dry
when you put your scanner on your cradle
to charge the battery. Wet charging pins
may cause water seeping into your cradle
and shortening its life.
Summary of Contents for ARGOX AS-9400BT
Page 1: ...AS 9400BT Cordless 2D Scanner User Guide http www argox com service argox com Version 1 0...
Page 109: ...AS 9400BT User Guide 101 6 Pin Assignments USB Type C RS232 USB...
Page 110: ...AS 9400BT User Guide 102 Appendix Numeric Bar Codes 0 1 2 3 4 5...
Page 115: ...AS 9400BT User Guide 107...