u
u
u
u
u
u
The battery compartment of the Active 10 can be found by removing the
Battery Back. Lift the metal D-ring on the back of the unit, rotate it a quarter
turn counter-clockwise to an unlocked position & lift the back off.
Next, remove the battery caddy (which holds AA batteries). Insert a small
flat-headed screwdriver into the 4 gaps in each corner to loosen the
catches. Once the caddy is loose, gently pull out the white wire connector
from the battery socket in the top left corner .
Take the white wire connector of the LiPol battery and slot it into the top
left battery socket , ensuring the
black wire is on the left
. Do not use
excessive force.
For the best fitting, make sure the label of the Lipol battery is facing
upwards. The wires should protrude from the right of the battery and fit into
the top right gap within the foam seal. Fix the battery into position in the
back of the unit.
Refit the Battery Back onto the back of the unit. Locate the tab at the base
and slide it into the unit first, making sure you do not trap the wires.
To secure the Battery Back into place, rotate the metal D-ring a quarter turn
clockwise to a locked position . (You may need to press down gently
to turn it).
F
E
G
H
K
I
J
Inserting the LiPol Battery:
3 Ways to Charge your LiPol:
The LiPol needs to be charged while in the Active 10. For optimum
performance it is important that you
only use Satmap products
to charge
the LiPol:
USB charging (via a computer using a USB Cable)
Mains charging (using the USB Cable and Wall Charger)
In-car charging (via the USB Cable and Car Charger)
1
2
3
LiPol Safety:
Only use specific charger.
Do not short circuit.
Do not disassemble.
Do not expose to high temperatures.
Do not incinerate.
Dispose of properly.
