6
RX-2K • RX-4K
SATEL
Note:
The button on the MPT-300 keyfob is not used when working in conjunction with the
controller.
Keyfob button
Controller
button
Channels controlled from
a keyfob
1 /
2 /
3 / 4 /
PRG1
1-4
1
2
3
4
PRG2
2-4
2
3
4
PRG3
3-4
3
4
RX-4K
PRG4
4
4
PRG1
1-2
1
2
RX-2K
PRG2
2
2
Table 2.
1. Press the selected controller button. The LED will start flashing green.
2. Press the keyfob button (in the case of the MPT-300 keyfob, press the
button). The
LED will start flashing red.
Note:
If the LED will turn on in green, it means that no more keyfobs can be enrolled or the
keyfob is not supported.
3. Press the same keyfob button again. The LED will turn on in green.
Enrolling a keyfob by using the DLOAD10 program
1. Click “Read transmitter” to read the data of keyfobs enrolled in the controller.
2. Click “New Transmitter”. The “New Transmitter” window will open.
3. Press the keyfob button (in the case of the MPT-300 keyfob, press the
button).
4. Press again the keyfob button when such a command is displayed in the “New
Transmitter” window.
Fig. 4. DLOAD10 program: “New transmitter” window.
5. You can enter your own name of the keyfob.
6. You can define the channels to be controlled by the keyfob (by default, it controls all
channels).
7. Click “Done” to close the window.
8. Click “Write transmitters” to write the keyfob data to the controller.
