4
KNX-BSA12L
• KNX-BSA12H
SATEL
The buttons are also used for restoring the module to its factory default settings
(see
“Restoring module factory default settings”).
red LED
– ON during physical address assignment via the ETS program and flashes
when the service mode is active. Address assignment can be activated manually by
using the
button on the enclosure or remotely from the ETS program.
programming button (used for physical address assignment). The button can also be
used to start the service mode in the module
terminal to connect KNX bus.
2.1 Enclosure
Electronics of the KNX-BSA12L and KNX-BSA12H modules is installed in enclosures of
identical shape and dimensions. The enclosures only differ in their panels for manual control
of channel state. The figure shows enclosure dimensions based on the KNX-BSA12L
module. The module takes up 4 units on the DIN rail (35 mm).
2.2 Operating the module manually
Manual operation allows you to control the movement of blinds/shutters using the buttons
located on the module enclosure (see p. 3). The blind/shutter control is possible after
configuring the module settings in the ETS program.
The weather alarm (see “Weather alarms” p. 25) and position forcing function (see
“Position forcing” p. 26) block the manual operation of the module. The manual control
is then interrupted and the blind/shutter is set to the position defined as the reaction to
the weather alarm / position forcing function.
2.3 Service mode
The service mode allows checking whether connections between the module and the
blind/shutter motors are made properly, and whether the module correctly detects the
blind/shutter movement. You can use the service mode before configuring the module
settings in the ETS program (e.g. to set limit switches when installing the blind/shutter).