SATEL INTEGRA
Plus
23
Entering names
Keep pressing particular keys until the required character appears. Characters available in
the keypad are presented in Table 3. Hold down the key to display the digit assigned to the
key.
Shown on the left side in the upper line of the display is information about the letter case:
[ABC] or [abc] (it will be displayed after pressing any key and will be visible for a few seconds
after the last keystroke).
The
key moves the cursor to the right, and the
key – to the left. The
key deletes the
character on the left side of the cursor.
Key
Characters available after next keystroke
1 !
?
'
`
" { } $ % & @
\ ^ | # 1
2
a
b
c
2
3
d
e
f
3
4
g
h
i
4
5
j
k
l
5
6
m n
o
6
7 p q r s 7
8 t
u
v
8
9
w
x
y
z
9
0
. , : ; + - / = _ < > ( ) [ ] 0
Table 3. Characters available when entering names. The lower case letters are available
under the same keys (to change the letter case, press
key).
2.2 D
LOAD
X program
Access to the program is protected by a code (password). To obtain access at the first run of
the program, enter the factory default code: 1234 (you need not enter the factory code, just
click on the "OK" button).
The factory access code to the program should be changed as soon as possible.
Entering an invalid code three times will terminate the program.
2.2.1 Main menu of
D
LOAD
X
program
Fig. 1. Main menu of D
LOAD
X program.
Explanations for Fig. 1:
1 - type of alarm control panel.
2 - name of data file (name of alarm system).