manualshive.com logo in svg

Satel ASD-110, Manual, Page: 3 / 4

Share
Download
Satel ASD-110 Manual Download Page 3

SATEL ASD-110 

3 

 

 
8.  Using a soft brush or compressed air, clean the labyrinth in the cover and the base of the 

optical chamber, paying attention to the recesses where the LEDs are installed. 

9.  Replace the cover of the optical chamber. 
10. Place the thermistor leads in the respective grooves. 
11. Replace the thermistor cover. 
12. Secure the electronics board with the optical chamber in the cover mounting catches. The 

board must be mounted so that the LED coincides with the light guide/button. 

13. Re-install the battery. 

Summary of Contents for ASD-110

Page 1: ...rates according to the requirements of Class A1R EN 54 5 The alarm will be triggered after exceeding a certain threshold temperature 54 C 65 C or in the event when the temperature rises too rapidly se...

Page 2: ...Check the level of signal received from the detector by the ACU 100 controller or by the INTEGRA 128 WRL control panel If necessary select another place for installation to ensure adequate communicati...

Page 3: ...s where the LEDs are installed 9 Replace the cover of the optical chamber 10 Place the thermistor leads in the respective grooves 11 Replace the thermistor cover 12 Secure the electronics board with t...

Page 4: ...down the test reset button designated with the letter A in Figure 1 to make sure that the detector works Alarm should be triggered after a few seconds 6 Specifications Operating frequency band 868 0 M...

Reviews:

No comments