4 AMD-102
SATEL
9. Screw the wires for roller shutter detector and/or NC type detector to the terminals on
electronics board.
10. Close the detector enclosure.
11. Secure the magnet, taking into account the maximum permissible distance from the reed
switch (Fig. 5). The distance shown applies to the magnet located at the reed switch height.
Location of the reed switches in the enclosure is shown in Fig. 3.
12. Configure the detector:
magnetic contact: define which of the two reed switches is to be enabled,
roller shutter input: program the pulse count (the number of pulses after which the input
will be violated) and pulse validity duration (the time counted from pulse registration during
which subsequent pulses must occur for the input to become violated).
For detailed information regarding configuration of the detector, please refer to the manual for
ABAX wireless system controller.
13. Start the test mode.
14. Depending on the configuration of detector, check that the LED goes on:
after moving the magnet away (opening the window / door),
after raising / lowering the roller shutters supervised by the roller shutter detector,
after violation of a detector connected to the M input.
SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gda
ń
sk • POLAND
tel. + 48 58 320 94 00
www.satel.eu
