6 ACU-220
SATEL
set the controller address (operating mode: expander of wireless devices for the
INTEGRA / INTEGRA Plus control panel).
3.2.1 Selecting the controller operating mode
Fig. 2. Switches defining the controller operating mode.
Switches 9 and 10
(Fig. 2) define the controller operating mode – see Table 1.
DIP-switch
Controller operating mode
9
10
Expander of wireless devices for the INTEGRA / INTEGRA Plus
control panel
OFF
OFF
Expander of wireless devices for the VERSA / VERSA Plus /
VERSA IP control panel
OFF
ON
ON
OFF
Universal module of wireless devices
ON
ON
Table 1.
3.2.2 Selecting the transmitting antenna
Fig. 3. Switch defining which antenna will be used for transmitting.
Switch 8
(Fig. 3) defines the antenna that will be used for transmitting:
OFF position – antenna 1 (AN1),
ON position – antenna 2 (AN2).
Thus you can select the antenna whose polarization is consistent with that of the antennas in
wireless devices installed in the system. This contributes to the quality of the radio signal.
Test the antennas to make sure which of them ensures better communication with the
wireless devices registered in the controller.
3.2.3 Address setting [expander of wireless devices for the INTEGRA /
INTEGRA Plus control panel]
Switches 1-5
(Fig. 4) are used to set the address when the controller is connected to the
INTEGRA / INTEGRA Plus control panel (in the other operating modes, the settings of
