SATEL
ACTIVA
5
Figure 10. Diagram of the barrier panel mounting parallel to the wall plane.
A
Insert the rear panel of the barrier housing (2) into the angular holder (1). Screw the two
components together with screws (3). Insert the tamper switch holder (4) into the mounting plate
guide (2) and tighten it with the screw (5). Insert the tamper switch (6) into the secured holder.
B
Connect the power supply cables and the synchronizing cable. Connect both tamper switches in
series (to do so, cut the longer cable of the mounting plate tamper switch and solder its ends, as
required, to the cables of angular holder tamper switch). Place the plastic cover of the housing
(7).
C
Push the cover in position.
D
Secure the cover, using the screw (8).
E
Using the screws (9), attach the holder to the wall. If the installation requires that the barrier be
positioned at a distance from the wall (in case when the beam path is obstructed by elements
protruding from the wall, e.g. parapet, drain pipes, etc.), use the spacers (10) – as they can be
connected together, the distance between the barrier and the wall is adjustable. A single spacer
makes it possible to move the barrier panel away from the wall by 6 cm, and each next – by
additional 4 cm. The spacers are not provided with tamper switch.
