SATA SATAjet 1800 M, Operating Instructions Manual

Page: 40 / 82

40
EN
Operating Instructions SATAjet 1800 M
11.2. Replacing the air distribution ring
Attention!
Damage from incorrect installation
The nozzle head can be damaged if too much force is used.
→ Always use SATA extraction tool.
Warning!
Risk of injury from sharp edges
There is a risk of injury from sharp edges when fitting the nozzle set.
→ Wear protective gloves.
→ Always use the SATA extraction tool pointing away from your body.
■ Dismantle nozzle set (see chapter 11.1).
■ Remove the air distribution ring
[8-1]
using the SATA extraction tool
[8-2] .
■ Check sealing surfaces for damage and soiling, clean or replace if
necessary.
Mount the air distribution ring
■ Insert the air distribution ring [9-3] in the nozzle head [9-1] . The pin on
the bottom of the air distribution ring must be aligned accordingly.
■ Press the air distribution ring in evenly.
■ Mount nozzle set (see chapter 11.1).
11.3. Replacing the paint needle seal retainers
If the paint needle seal retainer is damaged or worn, material can leak
from the inspection hole [1-3], [2-3] . Replace the paint needle seal re-
tainer immediately.
Dismantle the paint needle seal retainer
■ Unscrew the cap [10-1] .
■ Remove both springs [10-2] , [10-3] .
■ Remove paint needle [10-4] .
■ Pull the control piston out
[10-5]
.
■ Unscrew both fastening screws [10-6] with the Torx screwdriver.
■ Take the gun body [10-7] from the nozzle head [10-10] .
■ Remove the seal [10-9] .
■ Remove the paint needle seal retainer [10-8] .
■ Check seal and paint needle seal retainer for damage and soiling, clean