SATA 51073C, Operation Instruction Manual

Page: 12 / 20

12
may cause the corrosion or burning.
General safety warning of electric tool -
repair
1) Have the qualified maintenance personnel
to repair the electric tool with the same
spare parts. This will ensure the safety of
the electric tool being repaired.
Professional requirements
1) Be sure to take out the battery pack before
repairing the machine.
2) Do not place the machine in the rain or
water
3) Do not store the battery pack above 40 °C.
4) Charge the battery from 0 to 30 °C,
preferably 18 to 24 °C.
5) Only use the accompanied charger and
battery pack.
6) Avoid the short circuit of battery pack. (For
example: do not make the bolts and nails
touch the positive and negative poles of
battery pack)
7) Do not burn the battery pack or discard
it in the fire. Otherwise, an explosion may
occur. 8) Do not charge the damaged
battery pack.
9) Replace the damaged power cord timely.
10) Be sure to pull the plug off before
removing the battery pack.
11) During the charging, it is normal for the
charger and battery pack to heat up.
12) When the machine is not in use, do not
insert the charged battery pack into the
charger.
13) After the charging is over, please pull the
battery pack off the charger immediately.
14) During the operation, it is normal for the
body and battery pack to heat up.
15) Do not put the discarded battery pack in
fire or dispose it with domestic garbage,
and be sure to send it to the local
collection station or recycling point.
16) Carefully check for the cable, natural gas
or water pipes before driving the screw
or drilling the hole in the wall, floor and
ceiling.
17) Wear the earmuffs when operating the
machine. Otherwise the hearing may be
damaged.
18) During the operation, it is normal for the
accessories and metal parts to heat up.
19) The operating machine may come into
contact with the hidden wires. Therefore,
be sure to hold the insulating surface
of machine. Contact with the live wires
may electrify the metal on the surface of
machine and cause an electric shock of
user.
Battery pack leakage may occur if the operating
temperature is too high or the pack is excessively
used. If the liquid leaking from the battery gets on
the skin, wash it with soap first, then rinse it with
lemon juice or vinegar. In case of contact with the
eyes, rinse the eyes with clean water immediately
and go to the hospital for treatment.
Safety warning of electric wrench
1. If the fastener may touch the concealed
line, hold the tool at the insulating surface.
The fastener touching the live wire may
cause the exposed metal parts of tool to
be electrified to shock the operator.
2. Please wear the earmuffs
3. Please check the sleeve for any wear,
crack or damage before installation.
4. Please hold this tool firmly
WARNING
51073C