![background image](http://html1.mh-extra.com/html/sata/51012c/51012c_operation-instruction-manual_1200196019.webp)
19
V_SC_51012C_202105
QUESTION AND ANSWER:
1. Why does the machine not operate after the
switch is pressed?
A reversing yoke is located on the upper part
of switch. It is locked. Turn it to the position
where the rotation is in need, and then press the
button to rotate the machine.
2. Why does the hand drill stop when the screw
has not been tightened?
The machine has low-voltage protection. When
the level of battery pack is too low, the machine
will not work. Please confirm the level of battery
pack.
The machine has temperature protection. When
the battery is working at full load for a long
time, the battery pack will overheat and the
temperature protection system will start to
stop the machine. Cool the machine to normal
temperature before resumption.
Adjust the torque adjusting ring between
the body and chuck. The minimum torque
corresponds to position “1”, and the maximum
torque corresponds to position “21”. Setting the
torque adjusting ring to a higher position can
solve this problem.
3. Why is the service life of same kind of battery
pack is different?
As mentioned above, if a battery pack is left
unused for a long time, its service life may
be shortened. This is the matter of charging
frequency. Repeated charging and application
may improve the situation. In case of heavy
work, e.g. When the large screw is driven into
the hardwood, the battery pack will run out
soon. Do not charge in a temperature below 0 °C
or above 45 °C. Otherwise, the performance of
battery pack will be affected.
MAINTENANCE
Be sure to pull off the plug before repairing or
replacing the machine.
The electric tool does not require additional
lubrication or other maintenance. Do not wash
the electric tool with the water or chemical
cleaner. Wipe it off with a dry cloth. Tool shall
be stored under the dry conditions and kept
clean at the vent of motor. Try not to use it in a
dusty environment.
To prolong the service life of battery pack:
1) Store the battery pack below 26 °C after
charging it to 30%-50%.
2) Charge the battery pack fully once in less
than 6 months.
Summary of Contents for 51012C
