2
1.
Remove assembly screws from the base of thermostat. Gently pull the upper housing straight off the
base. Forcing or prying on the thermostat will cause damage to the unit. See figure 1.
2.
Connect wires beneath terminal screws on the base using appropriate wiring schematic. See figure 2
3.
Install two fresh “AA” alkaline batteries in battery compartment. Be sure to match positive (+) ends
of batteries with positive (+) battery terminals in the battery compartment. See figure 3
4.
Push power base into wall.
5.
Using mounting screws mount the power base to the wall. Place a level against bottom of base, adjust
until level, and then tighten screws. (Leveling is for appearance only and will not affect thermostat
operation.)
6.
Replace the upper housing on the base and fix the upper housing by removed assembly screw
CONFIGURATION DIL SWITCH SETTINGS
Slide the DIL switches to the settings required (see Figure 3)
Heating selection Cooling selection
Both heating and Cooling selection
Select
℃
and
℉
readout
Set the switch to
℃
, temperature in the display will be shown in
℃
readout.
Set the switch to
℉
, temperature in the display will be shown in
℉
readout.
Switch function option
ON/OFF – Switch at the lower side of the thermostat used as ON/OFF switch
Setting the switch at , thermostat is switched on.
Setting the switch at, thermostat is switched off.
NSB – Switch at the lower side of the thermostat used as NSB switch
Setting the switch at, thermostat is on comfort mode.
Setting the switch at, thermostat is on Night set back mode.
Compressor delay option for cooling selection
Setting the Dil switch at NO DELAY, compressor delay function is canceled.
Setting the Dil switch at 5 MIN DELAY, compressor will have 5 minutes off-time protection.
ON OFF
ON
OFF
ON
OFF
Summary of Contents for SAS816WHB-0
Page 8: ...4...
