24
Pairing the thermostat and the receiver
The units of the transmitter (thermostat or room unit) and the receiver
are connected (paired) by default. If not, follow the procedure below:
1.
Read the receiver's instructions for connecting or connecting.
mating.
(Quick summary: Press the button to turn off the receiver so that the red
LED is no longer lit. Then hold down the button for 3 seconds to turn on
the yellow LED. Release the key)
2. Turn off the thermostat so that OF is displayed on the screen. Carefully
remove the large temperature setting knob on the thermostat by lifting and
pulling it. When the button is removed, you will see a small black button under
the button location. When the receiver is in pairing mode, keep this button on
the thermostat pressed for 3 seconds (see picture to the right).
3. The devices should be now paired. "1" should appear on the screen.
The connection process is complete. If the process was unsuccessful, repeat
the process from the beginning or get help on our website, youtube channel or
contact us at [email protected].
Finally, put the thermostat in the same state as it was (easiest to turn the
dial completely to the left (first picture above) and have an orientation on
how to turn the knob back.
Summary of Contents for SAS816WHB-0-RF2
