SASFORKS EXTREME AUTO PROCESSOR, Manual

Page: 34 / 63

Introduction
Introduction
These assembly instructions must accompany the rotator until it has been
fully installed. The instructions must be added to the technical documentation
for the complete machine.
Designated use
• The rotator may only be used by trained personnel.
• The rotator must be manoeuvred from outside the risk area.
• The rotator is designed for positioning vertically-hanging loads.
• XR rotators are usually used for various types of grapple applications.
Note:
Note that the rotator needs a short braking distance before it stops fully.
Certain undemanded rotational movement may occur when holding loads due
to the vane motor's construction.
Due to the patented transmission that protects the motor, a certain play may
be noticed when changing the direction of rotation. This is perfectly normal.
Unauthorised use
• It is forbidden to mount/use a rotator on a machine where the risk area is
not sufficient.
• The rotator is not designed for pulling the base machine.
• No manoeuvring may take place if there are any personnel in the risk area.
• Continuous rotation may only take place when the rotator has achieved
normal operating temperature.
Installation requirements
• Maximum hydraulic pressure: see technical data .
• Maximum permitted revolution speed: XR 500/XR 600 20 rpm, XR 400 30
rpm, XR 300 28 rpm. This is controlled by oil flow from the base machine to
the rotator. Rotators not marked LS on the tag are delivered with flow
limiters.
• For max. axial load: see technical data .
2300028 2020-02-24 © Indexator Rotator Systems AB 1