4
The Inline Filter
The inline filter supplied with this unit will help prevent damage
to
the exhauster in case of failure of a primary
elongated
bags.
Should the air flow of the
SASE Bull
300
EBS
become reduced, check
that the inline filter has not become blinded by dust by removing the inline
filter housing cover.
In this situation, inspect the bags for damage, or to see if they have become
loose. Properly clean the bags if no damage is seen.
Remove the inline filter, and clean by back flushing with compressed air (NOT
recommended), or replace the filter.
Restart the unit. If after a short period of time, the inline filter becomes
plugged or blinded, replace the
elongated
bags
and
the inline filter element.
The standard replacement inline filter element re-order
–
refer
to parts list enclosed
The Other Mechanical Sub-Systems
VACUUM PRODUCER & ELECTRIC MOTOR
The
SASE Bull
300
EBS
features an AMETEK interrupter brush
vacuum producer
which is designed to run for approximately 800 hrs to
900 hrs with one set of interrupter brush that comes with the motor.. The
integral motors have permanently sealed bearings and do not require
periodic lubrication.
Please note!
The vacuum producer requires unrestricted air flow! Running
the
Bull
300
EBS
“deadheaded” for more than a few minutes will overheat
the vacuum
producer and void the warranty. THIS UNIT IS NOT
RECOMMENED FOR CONNECTION TO A CENTRAL VACUUM
PIPING NETWORK.
Section 4 & 5 of this manual features the vacuum producer data
sheets, wiring the motor and brush replacement procedure
respectively.
Please refer to that section for vacuum producer
troubleshooting and maintenance instructions.
Inline cartridge
element re-order
instructions.