Sartorius 16419, Operating Instructions Manual, Page: 13 / 43

Installation in an Isolator 13
Never autoclave the pump rotor and never submerge it into any liquid .
Only use a slightly moistened cloth | tissue for cleaning | desinfecting .
After cleaning, all parts should be secured as described in Chapter “6 Startup,”
page 9 . The rotor is assembled as follows:
– The rotor shaft has a groove on the side turned towards the back .
– Push the rotor upwards onto the shaft .
– Turn the marking on the rotor towards the back, so that the groove on the rotor
shaft aligns with the marking on the rotor
– Tighten the screw in the rotor to guarantee that the rotor is firmly seated .
10 Installation in an Isolator
The installation must be carried out by the isolator manufacturer .
To install the Sterisart
®
Universal pump in an isolator, it must be opened up first .
Make sure to unplug it from AC current (mains supply) before opening it!
During assembly, please follow the installation instructions precisely (part of the
installation kit for isolators, order number 1ZE---0050) . The instructions are available
separately from the manufacturer .
11 Important Notes Concerning the
Warranty
The correct functioning and safe use of the Sterisart
®
Universal pump is only guaran-
teed when it is operated according to the information given in these instructions .
The equipment manufacturer is responsible only for effects on safety, dependability
and performance of the instrument if assembly, extensions, new settings, changes or
repairs are carried out by persons authorized by him to do so, if the electrical instal-
lation in the room is in conformance with IEC requirements and if the equipment is
used in accordance with these operating instructions .
Any changes made to the Sterisart
®
Universal pump will invalidate the manufacturer‘s
warranty unless they are previously agreed to by authorized Sartorius Service staff, or
carried out by them .