Instruction Manual WOK-Induction Cooking Plate Model LOUISA
Operating
1. Put the plug into the plug socket. The net control light lights up. This indicates that the
cooker is connected with electricity mains.
2. Place suitable cooking utensils in the center of the top plate. Do not place the wok
without food on the cooker.
3. Switch on the cooker by pressing the ON/OFF button. The control light (POWER) lights
up.
4. Press the function button. The control light (POWER) continues shining. The cooker will
heat at the level 5. Set the cooker at the desired power by directly pressing to adjust the
power from 1 to 10 or 10 to 1.
5. Press the function button to select POWER, TEMP and TIMER as follows.
POWER: 1, 2, 3, 4, 5, 6, 7, 8, 9, 10
TEMP: 60°C, 80°C, 100°C, 120°C, 140°C, 160°C, 180°C
, 200°C, 220°C, 240°C
TIMER: 0, 5, 10, 10, ……..180; 5 minutes per interval.
6. The appliance is equipped with an overheat protection. If the wok is getting too hot, the
appliance will switch off power, a buzzer sounds and on the display occurs “E02”. Should
this happen, wait for some minutes and cool the appliance down. After that, the appliance
works without problems.
If meat or vegetables should be roasted, please use the temperature function to avoid
any over heating.
Cleaning
•
Clean after each use.
•
Allow the cooker to cool down.
•
Switch off the device and disconnect the power plug from the socket.
•
Wipe off the glass field with a damp cloth or use a mild, non-abrasive soap solution.
•
Make sure that the bottom of the cookware does not scrape across the surface.
•
Do not use benzine, thinner, scrubbing brush or polishing powder to clean the cooker.
Technical data
Model
LOUISA
Connection
230V / 50Hz / 1 Ph. / 3,5 kW
Adjustable heating level
1 - 10
Temperature range
60° - 240° C (heating level 1 - 10)
Timer
0 – 180 min.
Overheating protection
Dimensions
W 340 x D 445 x H 115 mm
Weight
net 7,5 kg
Error Code
Proable Cause
E01
Over heat of IGBT or damage of thermal resistor
E02
Damage of temperature sensor or protection of dry boiling
E03
Protection of over-low or over-high voltage, or impact current.
Please read carefully and keep it in a safe place near the induction cooker
. Page 2
