From 08/2015 IH
Page 7/10
Instruction Manual Induction Cooking Plate Model FINJA
7. Maintenance/Cleaning
•
After each use, the device must be cleaned.
For this purpose, disconnect the device from the power supply and let it cool down before you
start cleaning.
Discoloration or stains can occur on the hob from dirty cookware.
•
For cleaning, use a soft, damp cloth/dish cloth/sponge and a mild detergent.
Thoroughly wipe dry after cleaning.
•
Make sure that when cleaning the cable and the plug does not get wet.
•
Do not place into water!
•
Do not clean the device with aggressive chemicals, gasoline, thinner or scouring agents,
metal sponges, etc. so that the surface does not get damaged!
•
Periodically check the air intake and exhaust vents on the bottom side and on the rear panel.
Remove any dirt or blockages by suction using a vacuum cleaner.
The openings must be kept free for optimum ventilation of the device.
8. Error Messages
Notification
Error
Troubleshooting
E0
No cookware
or not suitable for Induction!
Only place cookware on the device suitable
for Induction.
E1
Device to hot
(for example, blocked ventilation
vents)
or
electrical parts damaged!
(for example, Transistor)
Remove cookware,
after the device has cooled down
check the ventilation openings,
remove blockages;
if there are still warning lights lighting up,
get the device checked/repaired by the
expert dealer.
Repair by a competent expert dealer!
E2
Overheat protection is activated and
the device is turned off.
Remove cookware,
leave the device to cool for a few minutes
When required, turn on the device again.
E3
Temporary over-voltage (Surge),
Device is to hot.
If the surge is not from a failure from the
mains, remove cookware,
leave the device to cool for a few minutes.
When required, turn on the device again.
