Operating Instructions
Bottle Cooler with Sliding Lid
Model B 1500 - order no. 323-4100
Model B 2000 - order no. 323-4105
General Information
•
Carefully read these operating instructions through as they contain important information.
•
Should you pass the bottle cooler to a third party, these operating instructions should be
handed over.
•
As soon as you have unpacked the cooler check whether everything is in a faultless
condition. Should anything be damaged, do not connect the coolder as such, but inform
your dealer.
•
Dispose of the packing material according to the local regulations.
•
The cooler has to be used only for cooling. Improper use can cause damages and lead to
the loss of warranty.
•
Do not use the cooler outdoors.
•
In case of fault and/or malfunction, pull the plug out of the socket and inform your dealer.
Repairs must be carried out only by qualified specialists.
•
The manufacturer/dealer cannot be made responsible for damages which arise through
not observing these operating instructions.
Installation
1. Please be careful during the transportation or moving of the cooler.
2. To prevent possible compressor damage, transport the appliance in upright position. If
the bottle cooler were not upright transported, you have to wait 2 hours, before you
connect it to electricity mains.
3. Remove the wrapping material and draw off slowly the plastic protection film.
4. Clean the outside of the cooler with a damp cloth and the grids with a soft, damp, warm
cloth and a commercial cleaning detergent. Wipe off and dry everything carefully. Do not
use aggressive detergents, steel wool or abrasive sponges. The cooler may not be hosed
down with water.
5. Place the cooler on a stable, dry and level surface, with suitable ventilation.
6. Situate the cooler in such a way, as to allow for the free circulation of air around it. That
is, with a least 100 mm of space all around it.
7. Keep the cooler out of direct sun or heat sources to ensure correct temperatures can be
achieved. Please note that optimal cooler performance is obtained at an ambient
temperature b16°C and + 35°C.
8. Before connecting the bottle cooler to the mains, make sure that the tension indicated on
the indentification plate agrees with the tension of your electricty mains. A safe function is
only possible if the cooler is grounded according to the valid safety regulations and
standards.
9. Do not use „double adapters“ or similar devices which allow numbers of electrical
appliances to be operated together from electrical outlet.
10. The cable must not come into contact with water.
11. Regularly check the cable. If it is damaged, it must exchanged by a qualified specialist.
12. Do not touch the plug with wet hands.
13. Plug the power plug into the suitable outlet.
14. Do not pull the plug out of the socket by the cable.
Page 1
