saro 456-1000, Instruction Manual

Page: 11 / 15

11
CHANGING THE DOOR HINGE

Remove the bottom hinge by loosening and removing the screws with a screwdriver.

Carefully lower the door and remove it.

Remove the two screws from the left upper hinge position, remove the sheet metal
part from the hinge position.

Remove the two screws from the right upper hinge and remove the hinge. Insert the
sheet metal part, then rivet the two screws.

Remove the lower hinge and fix it on the opposite side.

Take the door. Insert the axle of the lower hinge into the lower right hole of the door.

Attach the replacement hinge to the upper left position of the cupboard. Adjust the
door so that it lines up with the cabinet.

Note: Because the door seal is pressed in during shipping, the seal may need to be
readjusted after the door is turned over. This is good for the seal so that no air can
escape. If there is a gap between the cabinet and the door seal, insert the seal by
gently pulling it out to seal the gap. If necessary, it is also advisable to heat the seal
with a hair dryer to eliminate the gap.
CIRCUIT DIAGRAM