1
EN
COPY HERE
OPEN RACK ARMS / ABRIR BRAZOS DEL PORTABICICLETAS / OUVERTURE DES BRAS DU PORTE-VÉLO
Copy here...Use hex key located at the backside of the center beam to
adjust wheel block position. The four holes have been optimized for
fitting the front wheel. The chart reflects position of upper wheel holder
on front wheel. The rear wheel holder should be placed in the highest
location possible without going over center on the rear wheel. Due to
various bike sizes, this may not always correspond to the front wheel
holder position.
For bikes with rear rack or fender, position 3 or 4 should be used to
secure rear wheel.
Note: Wheel block should not touch fenders.
EN
6
WHEEL BLOCK POSITIONING
1
2
3
4
>26”
26”
24”
20” &
Rear Fender
28572A_MTR Instruction Manual.indd 11
2/19/2019 10:21:42 AM