12 1-800-810-WIRE • www.sargentlock.com • A8011E
Copyright © 2010, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
12/15/10
Passport 1000 Series P2 Mortise Lock
7 Install Gasket (Optinal)
Note: Optional, for non-fire rated doors only.
For non-fire rated door applications, an optional gasket may be
used as a weather seal between the escutcheon and the outside
door surface.
Peel off adhesive backing and attach to outside escutcheon.
Fig. 7A
Outside
Passport
Trim
Gasket
8 Install Outside Escutcheon and Mounting Plate Assembly
1. Insert the mounting posts through holes as shown.
2. On the inside of the door, position the mounting plate
over the indicated holes.
Note: Feed controller and keypad cables feed through side opening
(Fig. 8A).
Cable and ground ring terminal from lockbody
feeds from bottom (Fig. 8A and 8B).
3. Attach ground ring terminal lock body to bottom right
corner using one #8-32 x 1-7/8” flat head machine screw.
Make sure it is positioned upright (Fig. 8A).
4. Insert other three #8-32 x 1-7/8” flat head machine
screws and tighten, fastening the outside escutcheon
to the door (Fig. 8B).
IMPORTANT
: If the following step is skipped,
the product will not be UL-compliant:
5. Attach two (2) #8 x 3/8” flat head wood screws for
wood doors or (2) #8-32 x 3/8” flat head machine
screws for metal doors (Fig. 8C).
(4) #8 - 32 x 1-7/8” Flat
Head Machine Screws
Mounting Plate
Outside
Passport
Trim
Fig. 8A
Attach ground
wire to bottom
right screw
Lock Cable
Reader/Controller Cable
(2) #8 - 3/8” Flat Head
Wood Screws OR
(2) #8 - 3/8” Flat Head
Machine Screws
Fig. 8C
Fig. 8B
Mounting Plate
Position ground
ring terminal up-
right, then tighten
screw.
Lockbody Cable
Lock Ground
Controller/Reader
Cable
Reader Cable
(iCLASS only)
Reader Cable
(iCLASS only)
PRELIMINARY
