Step 8: Plug Cable Into the Keypad
• Plug the lock cable into connector on the PCB
• Ensure the arrow on the plug is facing up.
S
tep 9: Tucking Cable into Recessed Channel
• Place the lock cable into the recessed area.
• The excess cable should be folded and placed into the channel shown
at right. Ensure that no part of the cable extends above the wall of the
channel, since that will interfere with the keypad placement.
Step 10: Placing Keypad onto Base
•
Keeping the lock cable in its compartment, place the keypad onto the
base. The top seats into the base first, then the bottom.
• Carefully lower the top of the keypad so that the light green area slides
between the gold pins and the black plastic tab. Take care not to bend
the six gold pins. DO NOT use excessive force to insert the keypad.
Step 11: Batteries Installation
• Open clips as shown at right and prepare to insert batteries. Once
batteries are inserted, push clip closed. The battery clip will note latch if
battery is inserted backward.
NOTE the “+” on the 9V battery (small contact) and position it to match
the “+” on the Keypad base.
Step 12: Verify Lock Function
• To open the lock, use the factory setting for PIN position 10, with PIN
Code 101010. Enter: 10 101010 # and the lock willopen. (If lock
does not open compare beep patterns heard after pressing the # key,
with reference Section 2.3 “Beep Patterns” to identify problem condition.
Step 13: Install One Way Screw
• Install and tighten the keypad security screw as shown.
Step 14: Placing Chrome Ring Over Base
• Align Chrome Ring as shown and press down over the base.
• For future access to batteries, Chrome Ring can be lifted to expose
batteries.
