(9) Set AGC ON / OFF.
Please read the AGC Operation Guide for your reference.
(10) Set the M/S switch.
When using one channel, switch to M for mono.
When using two channels, switch to S for stereo.
(11) Set the LINE/MIC/PH switch.
When using microphones and wireless systems, set to MIC for microphone.
When using other audio devices, set to LINE for Line.
When using microphones operating on phantom power, set to PH for phantom power.
Note: Please DO NOT select Phantom level when recording with microphones that do not
operate on phantom power, wireless receivers, mixing boards or any unbalanced device,
because it may cause damage to both the adapter and audio device.
(12) Set the 12V or 48V according to your needs.
(13) Turn the adapter POWER switch to ON.
(14) Plug an earphone into the headphone terminal on the camera to monitor the audio. Please
make sure that both channels can be heard and adjust the gain controls if any distortion.
Be sure that the VOLUME control is set low to avoid excessively loud audio from damaging
your hearing.
(15) We suggest you could do a test recording and playback the audio to see if it is acceptable.
When test recording, you could adjust the knobs flexibly to get the the optimum signal levels.
2. Operation
2.1 Set up Guide
(1) Install the battery.
Lift up and pull out the drawer from the battery compartment.
Insert 9V battery into place al and - polarity as shown.
Slide the drawer closed until it clicks into place.
(2) Attach the SR-AX107 to the base of the camera. Spin counter-clockwise to tighten up the
adapter with the camera. Mount the adapter to a tripod with the tripod socket on the bottom
of the adapter.
(3) Connect the supplied signal transmission line from the output jack (OUT) of adapter to the MIC
input of camera. If there is a MIC / Line switch on the camera, select it to MIC.
(4) For monitor audio from the camera during playback, connect the supplied AV cable to the
MONITOR jack on the adapter. Attach the other end to the AV output of the camera.
(5) Connect balanced XLR microphones, wireless mics or other audio sources to the LEFT and
RIGHT XLR.
(6) Set the GAIN switches.
Set the Gain switches to HIGH for most microphones
Set the Gain switches to LOW for very sensitive condenser microphones or recording very
loud sounds
(7) Set the PEAK switches for both channel to ON.
(8) Set the MONITOR switch to PLAY to monitor the audio from the microphones during recording.
