Sarabec chimeflash, User Manual

Page: 2 / 2

Product Overview
Receiver Unit
1) Doorbell Icon (Green)
2) Ba ery Low Indicator
3) Speaker Port
4) General Bell Icon (Orange)
5) Flash Lens
6) Volume/Setup (Mul func onal)
7) Alert Type Selector
8) Power Supply Socket
9) Ba ery Compartment
10) Ba ery Compartment Door
11) Accept Bu on
Bellpush
1) Push Bu on
2) Push Indicator
3) Moun ng Bracket
4) Ba ery Cover
5) Ba ery Compartment
Ba ery Installa on
Insert 3 x “C” size alkaline ba eries into the ba ery
compartment on the receiver unit.
Remove the ba ery cover on the push transmi er
using a coin and insert the CR2032 ba ery (Posi ve
side upwards
)
.
Fixing and Wall Moun ng
Bellpush
We recommend a aching the bellpush moun ng plate to
your door or frame using the s cky pad already a ached.
The provided screws and plugs can be used for fi xing the
bellpush to masonry OR for wall moun ng the Receiver
unit.
The Bellpush should be fi ed to the moun ng plate at a
90 degree angle and then rotated either clockwise or
an ‐ clockwise un l a click is heard.
Receiver
The Receiver can be wall mounted, we would suggest
using the screws provided for doing this and mount the
bellpush using the s cky pad already a ached to the
moun ng plate.
Alert Type
chime
flash can be set to output Sound Only, Flash Only
or Sound and Flash together using the slide switch on the
side of the receiver unit.
Sound Only Flash Only Sound & Flash
Volume Control
There are 8 volume levels. Every level has a single beep
which corresponds to the volume level, when you hear a
double beep you have reached maximum volume.
The volume level can be set at any me except when in
setup mode. The chosen volume level is the same for
both transmi ers if using a second bellpush or telephone
transmi er.
Melody Selec on
There are 4 doorbell melodies and 2 telephone melodies
to choose from.
Press and hold the setup bu on for 2 ‐ 3 seconds to enter
setup mode, the green symbol will steadily fl ash. Release
the setup bu on.
If this is the symbol you would like to change the melody
of then simply rotate the setup bu on un l you hear the
sound you wish to keep. If you wish to change the sound
on the second symbol press the setup bu on once, the
bell symbol will fl ash and follow the instruc ons above.
Once the desired melody is selected press the setup
bu on to exit the setup mode.
Accept Bu on
This bu on can be used to acknowledge the
chime
flash
alerts, press this bu on any me when the system is
triggered, it will stop it immediately.
Ini al Setup
Note
: chime
flash
is pre ‐ programmed and ready to use once the ba eries have been inserted. Follow the instruc ons
below if you want to add a transmi er, set a melody or adjust volume.
The mul func on bu on/wheel has 2 func ons, fi rstly it can be pressed on its front face to enter the setup process,
secondly it can be rotated to select melody when in the setup, or to adjust the volume at any other me.
1) Press & hold the setup bu on for 2 ‐ 3 seconds, the
green doorbell symbol will illuminate and fl ash at a
steady rate.
2) Press the bellpush transmi er bu on, the green
symbol on the receiver will fl ash rapidly for 1 second and
a single beep will be heard, this indicates that the
bellpush and receiver are now paired.