Installation /
安裝
:
Step4 /
步驟四
:
Connect the power adapter (AC Plug) into the back of the switch, and then power on the unit. After that,
the Power LED will be on, and the Link/Act LEDs which
correspond to the Ethernet ports linked with PC or device will also be on.
將變壓器連接交換器背面的電源插孔，再插入電源插座。
此時交換器電源燈會亮起，交換器上有連接電腦或網路設備的網路連接埠的對應燈號也會亮起。
Q&A /
常見問題
:
Q1: The Power LED is off.
A1: The Switch is power off.
Please check whether the power adapter(AC Plug) is properly plugged in the socket. If it is well plugged,
make sure the socket is on.
Q2: Link/Act LED
is not lit for a connected device
.
A2: Please make sure the cable connectors are securely plugged in at the switch and the device. Also, check
the connected device is turned on and installed correctly.
問
:
電源燈未亮
答
:
電源燈未亮則無電源，請確認變壓器是否正確接再電源插座上。
若已接上插座，確定電源插座是在開啟狀態。
檢查變壓器是否已連接至交換器電源插孔，並確認沒有鬆脫。
問：網路接線連接埠的燈沒有亮
答：請確定連接交換器的電腦或是網路設備已開啟。
確定網路線有正確連接在交換器和電腦或是網路設備上。
Step 3 /
步驟三
:
Use Ethernet Cable to connect any Ethernet port on the switch with PC.
將網路線一端連接到交換器背後的連接埠，再將另一端連接到電腦。
Step 2 /
步驟二
:
Use Ethernet Cable to connect any Ethernet port on the switch with network devices (modem or router).
將網路線一端連接到交換器背後的連接埠，再將另一端連接到網路設備(數據機或是路由器)。
or
Power 指示燈 - 亮起表電源正常。
LINK/ACT 指示燈 - 恆亮時表示連線正常，
閃爍時表示該連接埠正在傳輸資料。
LED Indicators / LED
狀態指示燈
Power LED-LED is on means the switch is power on.
Link/Act LED-The solid LED means well connection,
and the flash LED represents data transmitting.
Step 1/
步驟一:
Install the switch in the rack with mounting accessory. Firstly, rivet the two "L" brackets onto each side of the
switch, then fasten it with screws in the 19-inch rack.(Only for HF-3024)
要將交換器安裝於機架上，首先必須將兩個
L
型耳翼固定於交換器兩端，之後再用機架螺絲將交換器固定在
19
吋機架上。
