7
What to do if you get picture interference when using RF lead
Option 1
If other stations are positioned on or near the current RF OUTPUT CH, the following guide message
appears automatically.
The RF output can be adjusted from 27 to 69 (For Australia), this video is defaulted to RF36.
The RF output can be adjusted from 21 to 69 (For New Zealand), this video is defaulted to RF36.
If other broadcasts are close to RF36 they may cause picture interference, you can change
the RF output until your television has a noise-free channel for your video.
Change the RF output from 36 using the
remote control.
Press
MENU
. Select ‘VCR Set Up’ by
pressing
PR-
twice then
OK
.
Select ‘RF Output Set Up’ by pressing
PR-
twice then
OK
.
Change the channel number using buttons
0-9
.
Press
OK
to confirm. Press
MENU
to end.
Option 3
Buy a RCA cable from your local electrical shop. Connect the RCA cable as shown on page
3, diagram 2.
If you want to change the RF output in the future due to new broadcasting stations or equipment and so on,
press and hold the
OK
button on the remote control until RF 36 is displayed on the front of the video. Then go
to option 2 above.
PLEASE CHANGE THE TV
CH TO 38.
IMPORTANT!
Press
OK
to confirm.
Press
MENU
to end.
Option 2
RF OUTPUT SET
0-9:SET UP (27-69)
OK:CONFIRM MENU:END
CH 36
RF OUTPUT SET
0-9:SET UP (21-69)
OK:CONFIRM MENU:END
CH 36
If there is still picture interference repeat option2.
RF OUTPUT SET
OK:CONFIRM MENU:END
CURRENT
CH 36
RECOMMENDED CH
38
For New Zealand
For Australia
DVYT7E34D-RJ/O+RJ/H
2006.5.23
2:42
PM
˘
`
7
