Sanyo SCP-4920, User Manual

Page: 35 / 230

End-of-Call Options
To display the following options, press
Options
(right softkey) within
10 seconds after disconnecting a call.
To select an option, highlight it and press .
䢇 Call Again
to dial the phone number.
䢇 Call:Speaker On
to dial the phone number in speakerphone mode.
䢇 Save Phone#
to save the phone number in your Contacts list.
䡲
Go to Phone Book appears when the number is already in
your Contacts list. (See “Saving a Phone Number” below.)
Note: The End-of-Call options are not displayed for calls identified as No ID or
Restricted.
Saving a Phone Number
Your phone can store up to 500 phone numbers in up to 300
Contacts entries (an entry may contain up to seven numbers). Each
entry’s name can contain 16 characters. Your phone automatically
sorts the Contacts entries alphabetically. (For more information, see
Section 2G: Using the Contacts Directory on page 80.)
To save a number from standby mode:
1.
Enter a phone number.
2.
Press
Options
(right softkey).
3.
Highlight
Save Phone#
and press .
4.
Select a label by highlighting
Mobile
,
Home
,
Work
,
Pager
,
Fax
,
Other
, or
No Label
and press .
5.
Enter a name and press .
If you have already stored entries in the Contacts list, you are
prompted to select the following entry modes:
䡲
New Name to enter a new name.
䡲
From Ph. Book to select a name from the Contacts entry list.
6. Press Save (left softkey).
After you have saved the number, the new Contacts entry is
displayed. (See “Contacts List Entry Options” on page 84.)
Section 2A: Your Phone – The Basics 24