Sanyo QuaDrive PLC-HF15000L, Service Manual, Page: 184 / 312

-184-
Status read command
The command is sent from PC to the projector with the
format below;
'CR' [Command] 'CR'
Command: one character (refer to the command table
below.
The projector decodes the command and returns the
'Character string' with the format below;
Format
command Function
Projector
return
Projector status
CR0 Status Read
00
Power On
80
Stand-by mode
40
Countdown
0
Cooling down
10
Power Malfunction
8
Cooling down at the temperature anomaly
0
Unable to receive the RC3C command.
4
Cooling down at Power Management mode
04
Power Management mode after Cooling down
1
Cooling down after the projector is turned off when the lamps
are out.
81
Stand-by mode after Cooling down when the lamps are out.
88
Stand-by mode after Cooling down at the temperature
anomaly.
C
Cooling down when the projector is turned off by the shutter
management function.
8C
Stand-by mode after Cooling down by the shutter management
function.
CR6 Temperature Read S1 S
S1 = Temperature at Sensor 1 (˚C)(Temp A)
S = Temperature at Sensor (˚C)(Temp C)
(ex.) S1 = 1.3˚C, S = 3.4˚C
--> The projector displays “1.3 3.4 ”
( For each sensor, two digit and the tenth place numbers are
displayed with a space between each temperature.)
?
Communication failure
The tables show the typical command lists for controlling the projector. Please consult your local dealer for further
information of other commands.
Serial Control