2
Installation
Connect the computer's monitor output
terminal to the projector's input terminal with a
computer cable.
30°
30°
Connect the Presentation Remote Receiver to
the USB port of your computer.
1
2
Computer cable
Presentation
Remote Receiver
Presentation
Remote Control
16.4’ (5 m)
✔
Note:
• The Presentation Remote Receiver can be connected to a standard
USB port only.
• Some computer settings may have to be changed in order for the
mouse function to be used. Refer to your computer's owner's manual
for details.
• When switching the remote control code of the projector and the
remote control, that of the presentation remote control also needs to
be switched. To switch the code, press and hold both the MENU and
IMAGE buttons for more than 10 seconds. (For details, refer to the
owner's manual of the projector.)
Presentation Remote
Receiver and Projector’s
IR Receiver.
To insure safe operation, please observe the following precautions:
●
Use (2) AAA or LR03 type alkaline batteries.
●
Always replace batteries in sets.
●
Do not use a new battery with a used battery.
●
Avoid contact with water or liquid.
●
Do not expose the remote control to moisture or heat.
●
Do not drop the remote control.
●
If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
●
Risk of explosion if battery is replaced by an incorrect type.
●
Dispose of used batteries according to the instructions.
Open the battery
compartment lid.
Install new batteries
into the compartment.
Replace the compartment
lid.
Two AAA size batteries
For correct polarity (+ and
–), be sure battery terminals
are in contact with pins in
the compartment.
1
2
3
Remote Control Battery Installation
Install the batteries into the Remote Control by
following the instructions below.
3
