-47-
SLOT-C
SLOT-B
SCREW-A
SCREWS-A
SCREW-A
SLOT-B
SLOT-C
SCREWS-A
SCREWS-A
■
Condenser-lens adjustment
■
Relay-lens adjustment
Shade
Before Adjustment :
1. Remove the connector K8E, connector K8N, connector
K8P and the flexible cables of LCD panels from the
assembly Main. And turn on the projector.
2. Insert light block sheet in front of the blue panel to block
the blue light so that yellow
(Green and Red lights)
light is pro-
jected.
3. If the shade appears on the screen, adjust in the following
procedure.
Adjustment :
1. Set the assembly-Main to the upright position.
2. Loosen four screws-A.
3.
If it appears on the top or bottom.--->
Use slot-B.
If it appears on the left or right. ----->
Use slot-C.
--
Insert slot screwdriver into each slot, turn it and erase shade. --
4. Tighten the four screws-A to fix the condenser-lens unit.
Before Adjustment :
1. Remove the connector K8E, connector K8N, connector
K8P and the flexible cables of LCD panels from the
assembly Main. And turn on the projector.
2. Insert light block sheet in front of the red panel to block
the red light so that cyan
(Green and Blue lights)
light is project-
ed.
3. If the shade appears on the screen, adjust in the follow-
ing procedure.
Adjustment :
1. Set the assembly-Main to the upright position.
2. Loosen four screws-A.
3.
If it appears on the top or bottom.--->
Use slot-B.
If it appears on the left or right. ----->
Use slot-C.
--
Insert slot screwdriver into each slot, turn it and erase shade. --
4. Tighten the four screws-A to fix the Relay-lens unit.
Shade
Shade
Shade
J/C
J/C
